I was going to install a 12v 4.5a/h gel cell up in the bows, but it didn't fit (grrr!) so I've ordered a 12volt 3700a/h nicad pack specially made to fit the space available.
Flood holes are drilled, shaft is temporarily fitted, so next job is to make a start on the detailing of the conning tower, finish off the 'scopes, and then make up the few bits on the deck.
I think I've worked out how to release the torpedoes, but that entails much brass work, so there's a job for my tame engineer. A friend in Bristol is getting the metal work that supports the rudder and rear dive plane made up for me, and as you know, Alfie is going to make the torpedoes operational.
Without the help of Alfie, Andrew Gray and his friend Terry, Dave at ACTion Electronics, Kevin Coombs, Ramesh, Andy Lawrence, Andy Oakley, and the two Paul's...Cook and Holman, I wouldn't have even got this far with the build...I thank you all for your advice, assistance and hard work on my behalf.
Last edited by Richard(Admin) on Sun Apr 24, 2011 1:54 pm; edited 1 time in total
Yesterday at 11:02 am by stig58
» Cheap Arduino Auto leveler
Sat May 11, 2024 6:53 pm by 17b
» No reverse on Brushless ESC
Tue May 07, 2024 3:26 pm by geofrancis
» Peral Submarine of 1888
Mon May 06, 2024 11:16 am by david f
» Newbie needs advice!
Fri Apr 26, 2024 1:58 pm by david f
» Modulated electric fields for submarine communication in a "heads up" from Harry!
Sun Apr 21, 2024 6:09 am by geofrancis
» 868/915 Mhz as a viable frequency for submarines.
Wed Apr 10, 2024 5:48 am by tsenecal
» Laser cut Robbe U47 conversion
Tue Apr 09, 2024 3:40 pm by david f
» ExpressLRS - 868/915 Mhz equipment
Tue Apr 02, 2024 3:27 pm by tsenecal