I've been thinking of building an r/c shark fin for a long time, so as I was feeling reaonably healthy today, I've made a start on it.
The shark's body is the top section of an old MMB(Mark's Model Bits)SubSonic sub, with the fin made from styrene sheet and simply glued into a slot cut and filed into the little sail on the deck.
The radio will be going into an ordinary wtc fixed under the deck, probably just velcroed into position. I'll be fitting a small lead bulb keel to keep the fin upright, but that's for later on.
It's being built just for a bit of fun sailing really, maybe I'll take it to a show for the kids to play with.
Here's the fin so far...
And before my old mate Andy(tattooed)pulls me to one side....yes mate, I did wear my mask whilst I was drilling and filing.
The shark's body is the top section of an old MMB(Mark's Model Bits)SubSonic sub, with the fin made from styrene sheet and simply glued into a slot cut and filed into the little sail on the deck.
The radio will be going into an ordinary wtc fixed under the deck, probably just velcroed into position. I'll be fitting a small lead bulb keel to keep the fin upright, but that's for later on.
It's being built just for a bit of fun sailing really, maybe I'll take it to a show for the kids to play with.
Here's the fin so far...
And before my old mate Andy(tattooed)pulls me to one side....yes mate, I did wear my mask whilst I was drilling and filing.
Yesterday at 11:02 am by stig58
» Cheap Arduino Auto leveler
Sat May 11, 2024 6:53 pm by 17b
» No reverse on Brushless ESC
Tue May 07, 2024 3:26 pm by geofrancis
» Peral Submarine of 1888
Mon May 06, 2024 11:16 am by david f
» Newbie needs advice!
Fri Apr 26, 2024 1:58 pm by david f
» Modulated electric fields for submarine communication in a "heads up" from Harry!
Sun Apr 21, 2024 6:09 am by geofrancis
» 868/915 Mhz as a viable frequency for submarines.
Wed Apr 10, 2024 5:48 am by tsenecal
» Laser cut Robbe U47 conversion
Tue Apr 09, 2024 3:40 pm by david f
» ExpressLRS - 868/915 Mhz equipment
Tue Apr 02, 2024 3:27 pm by tsenecal